After you reset the washer it should work fine.
Top loading washing machine shakes during spin cycle.
In theory when your maytag washer reaches its spin cycle it should begin spinning.
The shock absorbers or struts are attached to the base frame and to the outer tub and you will need to remove the front panel or the rear panel to access them.
When shock absorbers weaken or become damaged unbalanced loads will cause the washer to shake or move and the machine will often make a loud banging sound during the spin cycle.
As it spins it will simultaneously throw water out of the appliance through the drain hose which empties into a sink or drain pipe.
When you wash one large bulky item such as a blanket or comforter it can hug one side of the machine during the spin cycle.
A single large wet item such as a comforter or blanket can hug one side of the washer during the spin throwing the washer off balance and causing it to vibrate.
Adding one or more towels or redistributing the weight and resetting the washer can often solve this problem.
You may be able to reattach the spring but most likely you ll need to purchase a new suspension rod.
Transmission is worn out 8.
Assuming you have a front loading washing machine recommended for energy efficiency you can access the suspension springs through the top panel.
If they are broken or damaged however the washing machine may shake violently when it enters the spin cycle.
Washing machine making noise during the spin cycle.
Once the washing machine sees the load is properly balanced the spin cycle continues and ramps up to maximum rpm with minimal vibration.
The short pause and vibration when the washer spin cycle reaches approximately 400 rpm is a normal.
Main tub bearing faulty 2.
Reasons a washer will make noise during spin mode.
Motor coupling worn 4.
When the washer is spinning a loud noise can be heard if a spring should become weak or out of place.
Springs or dampening straps.
These go between the outer tub and the base frame to moderate the shaking of the tub during the spin cycle.
To solve this problem you can generally add one or more towels to redistribute the weight.
Main drive pulley 3.
Shock absorber front loader washers 9.
Worn out drive belt 6.
If you have been hearing a loud banging noise from your top loading washing machine and it is shaking and moving during the spin cycle you ll want to check on the shock absorbers or struts.
These springs are used to suspend the basket from the frame.
This will throw the washer off balance and cause it to shake violently.
