Tongue And Groove With Table Saw

Every woodworker should be familiar with cutting them on the table saw.

Tongue and groove with table saw.

The cuts made when creating the two mating workpieces of a tongue and groove joint are non through cuts meaning that the saw blade never goes all the way through the wood. In our case the legs are much thicker than the rails so we can t flip the boards end for end to center the groove. Measure the face width of the existing flooring add the width of its tongue then set the table saw s fence that same distance away. To produce a tongue and groove on the table saw use a dado cutter rather than your everyday blade unless your stock is 3 8 or less in thickness.

For the tongue use a regular blade also. When making tongue and groove with a table saw it s always important to practice safety at all times. I use the two outside cutters to produce a 1 4 cut width when working 3 4 stock. Measure your tongue opening to try and get the proper fit but use a scrap piece to make trial cuts until you get a snug fit.

Tongue and groove is one of the strong wood joints used to fit similar wood boards together to create a. It could be 1 4 to 3 16ths wide. Run your piece on both sides. Improve wood skills with help from a woodworking expert in this free video on working with a.

Save yourself a bundle by cutting your own wood to width. Thicker stock calls for a wider groove. The tongue and groove joint can be easily created using a router with a matched set of router bits or on a table saw using a stacked dado blade set. Make the usual double pass to guarantee that your groove is exactly centered.

When joining two matched boards into one a tongue and groove joint is much stronger than a simple butt joint. The tongue and groove is one of the most basic and useful joints.