Tongeue V Groove Ide Laminate

The most common shape of groove and tongue flooring is the plank with a width that ranges from 2 1 4 to 6inches and various lengths.

Tongeue v groove ide laminate.

The tongue on laminate flooring is the small flat edge on one side of the board this is the top edge that is going to angle and lock into the bottom side of another board. Installing tongue and groove boards is a quite fast and affordable way to panel any ceiling or wall. Start on the wall opposite the door and lay down your first board groove side facing the wall. On the other side you ll see a smooth half round lip that extends and runs from end to end.

In t g wood flooring the tongues are cut into one long and one short side while the grooves occur on the two remaining sides. Which side is the tongue which the groove and which goes first during installation the tongue is the side that you will want to place against the wall as you start your laminate flooring installation. Installing laminate flooring install the tongue towards the wall you are starting on. The opposite side the bottom side will contain the groove edge which is a larger wider side that contains a lip to hold the boards together when locked.

By lining up the ridge side of a board with the groove side of another board and attaching them a snug seam is created. Engineered flooring offers more installation options and applications than solid wood tongue and groove flooring. One tongue fits firmly into the groove of the adjoining board. Constructing with tongue and groove works by using boards that have one side with a protruding ridge the tongue and a groove along the entire length of the board s opposite side.

These prevent warping when the laminate expands and contracts due to changes in humidity. Lay down your second board against the wall remembering spacers and fit it into the tongue and groove. Tongue and groove hardwood planks are all the same width but may not be the same length. On one long side of a plank you will find a groove that runs from end to end.

Engineered tongue and groove flooring is similar to solid wood flooring but has a plywood like construction consisting of thin layers of wood glued together to form a plank. Make sure to place spacers between the wall and the board. Tongue and groove are often used in conjunction with wood floorboards sheet paneling wainscot and any number of other materials where a tight solid seam is required between separate pieces. The top layer is usually hardwood and is typically prefinished.

Solid wood engineered and laminate. The tongue and the groove each run the entire perimeter of the piece on all four sides. To lock the planks together you tilt one plank up slightly insert the tongue over into the groove and then rotate that plank down locking the joint.