Toilet Flange In Floor Removal Instructions

Rest the toilet bowl on its side place it on a towel or cloth to protect the floor and attach the replacement wax ring to the bottom of the bowl this technique helps ensure the ring is in the proper position when placing the toilet over the flange.

Toilet flange in floor removal instructions.

These bolts will fit into the toilet floor. There are two options this step. When your toilet flange is unlevel or not set to the right height the toilet may wobble or even leak at the base. Remove the old wax that sealed the toilet to the flange and pipe with a putty knife.

Keep the screws safe because you can reuse them later. Remove the old flange. Fix the toilet flange on concrete floor. If the flange is sitting only about inch of the floor it is possible to use a wax ring sealed in place to fix this small gap.

It is best that the flange is level with the floor. You will either need to break the. Simply scrape it off and smear it on the newspaper until you can access the top of the flange. Pry off the trim caps on the floor bolts if necessary and then remove the nuts from the floor bolts with an adjustable wrench.

Next install a new wax ring. Discard in a trash bag. Step 6 removing the flange. Remove the toilet and put it in a secure place.

Clean away any remaining wax from around the flange and remove the screws which are fixing it to the floor. The higher a flange sits above the floor the greater the likelihood of poor fitting and problems with the toilet leaking. Mount the new flange on the floor with new bolts. Remove the broken area from the flange to be repaired using a hacksaw.

To eliminate these issues it s important to ensure your flange is set to the right height and if it s broke or damaged in any way you ll also want to replace it. Clean the wax from the flange seal and remove the screws that attach the flange to the floor. Attach the new flange securely to the floor with new screws. When removing the toilet flange the methods used will vary depending on the type of material your flange is made from.

If that doesn t work you may have to cut the bolts with a hacksaw or split the nuts with a nut splitter.